The form 4's address remained the same. The new address is shown on the atf form 5320.20. I assume if you were to sell a nfa item you would use a copy of your form 4 along with the form 5320.20. Again my are on form 4 individual.

I did a change of address a couple of months ago and used atf form 5320.20. All of my nfa items are on form 4 individual.

Thank You for the nfa tracker page.

Does anybody happen to know the weight of a all s/s scarab?
Thanks in advance

I have one with a .400 bore made of s/s. I have used it for 9mm up to a 30-06. Works great no problems.

jonscott1983, could you describe your method for cleaning your pilot in the ultrasonic cleaner, as for as solution, lenght of time in the cleaner, etc.? I have aac sacarb I was thinking of cleaning in my ultasonic cleaner.
Thanks Garry

I bought the scarab used and it had less than 200 rds through it. It was made around 2001. It weighs 8.2 oz. Just thoght it maybe stainless through out. I bought it from a buddy so the round count is accurate.

What is the weight of a all Stainless steel Scarab? Thanks

Check on gunbroker.com

Thanks Jeff, they had just what I was looking for.

Where can you purchase a 1/2x36tpi and 7/16x28tpi tap and die? Thanks

Thanks Artful, that just what I was looking for.

What are the chamber pressures for a 10.5, 11.5 and 14 inch barrel lenghts for a M16? Thanks

South Bend puts out a book called "How to run a lathe". The book costs
very little. I bought the book and South Bend 10k and learned that way.
Good Luck

Racer , Here is my e-mail address: [email protected], If you like e-mail your e-mail address and I'll e-mail you a picutre of the can. Thanks Garry

Thanks Racer, My is a two stage. It looks somewhat like yours, but my has grease in the end of it. Also did mac make them or did somelse make them for mac? I tried to paste a picture of my on this thread but it was a no go. Thanks again

I just picked up my MAC can and would like to know the best way to clean it, and how often? Also if someone has a picture of it disassmbled, is
there anyplace where you can get a manual for it. Thanks

I have a blalock gun works silencer model ar-30 waiting on a form 4, Does
anyone know the diameter and thread pitch? It's not 1/2 -28tpi. Thanks for
any help.