SWR was acquired by SilencerCo about 4 years ago.

We still warranty all of their products

We should have some available next month.

With 2 3/4" shells the Salvo is rated down to a 10" barrel.

With 3" shells the Salvo is rated down to a 16" barrel.

No 3 1/2" shells.

I bought a 3/4" wooden dowel at Home Depot and cut it to length. The first time I used it, I had to whack on it pretty hard for it to come out. Now it comes out pretty easily. YMMV of course. You could also just send it back to SilencerCo. Good Luck... This is correct. A 3/4" wooden dowel...

The Specwar muzzle devices are 2.46" in length. Still long enough to bring a 14.5" to the 16" when permanently attached

We will be making an adapter and it should be available end of this month.

SRI has made some adapters already that have our o-ring engagement

The 45 Osprey is rated for use with 10mm

You will be fine. The Spectre is rated for use with calibers from .22lr up to .22 Hornet

There's no back log. All of our sales are through distributors. I would suggest checking with your dealer to make sure he actually made the order with a distributor.

The Saker 762 is rated and warranted with 6.8SPC down to a 7" barrel.

Whenever you run the Osprey or the Octane on a fixed barrel you will want to use the fixed barrel spacer or the direct thread mounts (Octane Only). If you don't do this the suppressor still moves and essentially turn the suppressor into an air hammer and we have seen it break barrels.

If the piston isn't fitting after a lot of 3-lug use then you will want to clean the blast baffle and the bird cage.

Yes it can. The Sake muzzle devices are 2.62" in length. We recommend pinning and welding on the wrench flats so that it does not interfere with the mounting of the Sake muzzle device.

The Specwar 762 is rated and warranted for the following minimum barrel lengths:

7"- 5.56, 6.8SPC, .300blk
12"- .308 and other standard calibers
20"- Magnum calibers up to .300RUM

It sounds like your 3-lug on your barrel might not be in spec. If you want you can send everything into us and we will spec it all out, if it's our 3-lug mount then we will correct it if it's your barrel then we can steer you in the direction to go to get it fixed.

We do not intend to make a mount for Surefire muzzle devices because there are too many types of too variant designs for us to cover all the mounts.

The Y-mount is in final testing and manufacturing right now and it will be available in Q3 of this year.

The anodizing will start to come off on the back side because it is getting hit with unburnt powder and other debris. If think your 1/2x28 mount is not in spec you can send it back in to us and we will get it inspected to make sure it is in spec.

You will be fine using a suppressor cover on your Saker and it won't void your warranty.

That was an old design that we didn't end up using.

There are no o-rings in the standard thread pistons. Only metric threaded pistons call for the o-ring.

The 13.5x1 LH piston o-ring's size is 1x12mm

We do not recommend it. It will put a lot of stress on the mount and on the ring that engages the teeth on the muzzle device.

The 15x1 are bored for .308 you will be fine using it on your HK91

The Stellite we use is proprietary.

The Saker and the Specwar use the same Stellite.