threading titanium tube for endcaps

Yes, it can be legal to make a silencer. For everything Form-1, from silencer designs that are easily made, to filing forms with the BATF, to 3D modeling. Remember, you must have an approved BATF Form-1 to make a silencer. All NFA laws apply.

Moderators: mpallett, bakerjw

User avatar
L1A1Rocker
Silent But Deadly
Posts: 3578
Joined: Wed Feb 21, 2007 7:40 pm
Location: Texas Hill Country

Re: threading titanium tube for endcaps

Post by L1A1Rocker » Sun Jun 22, 2014 11:54 pm

kingjamez wrote:I know I'm late to the thread.

I made a youtube video on single point threadmilling. I'm a huge Bobcad user and fan, but Advent 2008 is free and does a very good job. I did an AR-15 lower in Titanium and thread milled the buffer tube exactly the same way I did it in aluminum in the video below. I just adjusted for the correct feeds and speeds.

https://www.youtube.com/watch?v=rRzCDZt8ZsY

-Jim

Most excellent. It's a shame the pool of people that can appreciate what you did is so small.

Shady
Member
Posts: 26
Joined: Thu Apr 04, 2013 6:32 am

Re: threading titanium tube for endcaps

Post by Shady » Tue Jun 24, 2014 4:21 pm

You are my HERO!!!! :)

very detailed and I am sure it will help me get it done.

Post Reply