9mm blueprint + questions
Posted: Wed Jul 23, 2014 4:14 pm
Hi,
with form 1 and metals in hand, id like to get a 2nd opinion before i begin machining.
here is the build i'm working on for 9mm:
-2024 AL tubing .08 wall thickness encasing a 7075 AL monocore with .012 clearance, and steel endcaps.
-5mm thick baffle/ chamber walls
- was thinking of just doing simple V shaped baffles, would another pattern be better? (in a manual mill/lathe)
-10mm bore
-was thinking of putting some pins in the end of each end cap so i could lock them in so they dont come unscrewed
questions i have:
-How large of a space between baffles?
-Is V baffle fine?
-does my blastchamber sizing/design look alright?
-Should the end cap that is farthest from the muzzle thread into the core like i have shown, or should i thread it around the outside of the core?
*ANY* additional concerns/comments/thoughts/tips/suggestions would be greatly appreciated.
Thanks guys !
with form 1 and metals in hand, id like to get a 2nd opinion before i begin machining.
here is the build i'm working on for 9mm:
-2024 AL tubing .08 wall thickness encasing a 7075 AL monocore with .012 clearance, and steel endcaps.
-5mm thick baffle/ chamber walls
- was thinking of just doing simple V shaped baffles, would another pattern be better? (in a manual mill/lathe)
-10mm bore
-was thinking of putting some pins in the end of each end cap so i could lock them in so they dont come unscrewed
questions i have:
-How large of a space between baffles?
-Is V baffle fine?
-does my blastchamber sizing/design look alright?
-Should the end cap that is farthest from the muzzle thread into the core like i have shown, or should i thread it around the outside of the core?
*ANY* additional concerns/comments/thoughts/tips/suggestions would be greatly appreciated.
Thanks guys !