How much clearance should I have to the I.D. of tube? This is for my 300 blk can that has an O.D. of 1.625. I'm not sure what others have used in the past and I think I tend to make them a bit tight.
Thanks for any info ya'll have on this.
Baffle clearance to I.D. of tube?
- L1A1Rocker
- Silent But Deadly
- Posts: 3578
- Joined: Wed Feb 21, 2007 5:40 pm
- Location: Texas Hill Country
- john.t.little1
- Silent But Deadly
- Posts: 243
- Joined: Thu Nov 24, 2011 12:13 pm
- Location: florida/iraq
Re: Baffle clearance to I.D. of tube?
I made mine a press fit but I've seen others where they could almost slide in and out
"A man is known by the silence he keeps. - Oliver Herford"
"Gunpowder, treason and plot. I see no reason why gunpowder, treason
Should ever be forgot..."
"Gunpowder, treason and plot. I see no reason why gunpowder, treason
Should ever be forgot..."
Re: Baffle clearance to I.D. of tube?
I make my K baffles just shy of press in clearance. No issues with .050 overbore from caliber. But, YMMV as I have a grand total of 2 complete Form 1s under my belt. 1 aluminum .22LR, 1 stainless 5.56. I am just now starting a Titanium 300 Blackout myself & hope it performs as well.
Still awaiting an original & riveting thought for signature line; stand by...........
Re: Baffle clearance to I.D. of tube?
I've seen .005 recommended here frequently. My last 2 were .007 & that seems to make them come apart dirty with a lot less encouragement.
Consider baffle strength, how you plan to clean it, & how frequently you'd like to disassemble it.
Consider baffle strength, how you plan to clean it, & how frequently you'd like to disassemble it.
--------------------------------------
"Sorry but you cannot use search at this time. Please try again in a few minutes"
"This board is currently disabled"
These things make me
"Sorry but you cannot use search at this time. Please try again in a few minutes"
"This board is currently disabled"
These things make me
- L1A1Rocker
- Silent But Deadly
- Posts: 3578
- Joined: Wed Feb 21, 2007 5:40 pm
- Location: Texas Hill Country
Re: Baffle clearance to I.D. of tube?
Thanks guys. It is much appreciated.
Re: Baffle clearance to I.D. of tube?
Resurrecting this old topic. When you say clearance, are you referring to radial or diametrical? I.e., .005 per side or .005 total clearance (that would be .0025 clearance per side).
Re: Baffle clearance to I.D. of tube?
I go 0.005 under in diameter, not per sidespeed6 wrote:Resurrecting this old topic. When you say clearance, are you referring to radial or diametrical? I.e., .005 per side or .005 total clearance (that would be .0025 clearance per side).
Re: Baffle clearance to I.D. of tube?
Thanks for the clarification.