Cerakote on a Suppressor - turned out well

Yes, it can be legal to make a silencer. For everything Form-1, from silencer designs that are easily made, to filing forms with the BATF, to 3D modeling. Remember, you must have an approved BATF Form-1 to make a silencer. All NFA laws apply.

Moderators: mpallett, bakerjw

Post Reply
User avatar
Jer
Silent Operator
Posts: 72
Joined: Thu May 02, 2013 3:32 pm
Location: Buckhannon, WV
Contact:

Cerakote on a Suppressor - turned out well

Post by Jer »

"Those who make peaceful revolution impossible, shall make violent revolution inevitable." - John F. Kennedy.
User avatar
CMV
Silent But Deadly
Posts: 757
Joined: Thu Feb 09, 2012 4:31 pm
Location: NC

Re: Cerakote on a Suppressor - turned out well

Post by CMV »

Looks good.

That's how all mine are finished except one Ti that is anodized for prettiness :)

Cerakote recommends an HVLP spray gun as shown in the video. That's what I started with and found out I get much better results and much less waste using an airbrush - esp for small parts. Also, be sure to use the C series and not the H series for anything that will get hot like a suppressor.
--------------------------------------

"Sorry but you cannot use search at this time. Please try again in a few minutes"
"This board is currently disabled"
These things make me :(
User avatar
Jer
Silent Operator
Posts: 72
Joined: Thu May 02, 2013 3:32 pm
Location: Buckhannon, WV
Contact:

Re: Cerakote on a Suppressor - turned out well

Post by Jer »

Good hell.
It took forever and it's not what I had envisioned, but it's what I had time to do.
I'm breaking down everything and packing for my move to Las Vegas - so this will be the last video I make until +/- September.

But here is the reveal video:
[youtube]https://www.youtube.com/watch?v=ybaBHS0xPqc[/youtube]
"Those who make peaceful revolution impossible, shall make violent revolution inevitable." - John F. Kennedy.
Post Reply