9mm Form 1
9mm Form 1
New to NFA stuff. Finally set up a trust and have a couple items in it and a few pending. Just got my form 1 back for a 9mm 9" long suppressor. This will be going on my 7.5" 9mm AR SBR. Whats a good dia tube to use? Would like to build it strong enough to handle a 300 blk when the stamp comes back for it.
Re: 9mm Form 1
Hole size for 9mm is pretty common in Titanium valve retainers so I would go that route.
- T-Rex
- Silent But Deadly
- Posts: 1865
- Joined: Wed Oct 29, 2014 3:38 pm
- Location: CT - The AntiConstitution State
Re: 9mm Form 1
From seeing c5_nc's builds, which are fantastic, I would recommend the retainers over freeze plugs.
Yes, the Ti retainers are costly, but you'll have a much better finished product.
Yes, the Ti retainers are costly, but you'll have a much better finished product.
Completed Builds www.silencertalk.com/forum/viewtopic.php?t=79895
Burst Calculator www.engineersedge.com/calculators/pipe_bust_calc.htm
Silencer Porn www.instagram.com/explore/tags/silencerporn/
Burst Calculator www.engineersedge.com/calculators/pipe_bust_calc.htm
Silencer Porn www.instagram.com/explore/tags/silencerporn/
Re: 9mm Form 1
Think in going with a titanium tube from sdt and titanium valve retainers. Have to research the best style to clip them. I have access to a bridge port at work.
Re: 9mm Form 1
Funny. I just sent in one for 9mm 9" tube. Ordered some ti tubing and some 7075 alum. It's going on a 5" barrel AR. I can't wait