Page 1 of 1
1.625 Tubes
Posted: Wed Jan 01, 2020 11:24 am
by EastTxHorn
I'm looking for some 1.625 OD, 1.5 ID tubes. I've looked at every place I know of. All backordered. Does anyone have the ability to thread a couple or have a source for 9.5"?
Re: 1.625 Tubes
Posted: Thu Jan 02, 2020 1:19 pm
by #40Fan
HawkTactical on the Form 1 board.
Re: 1.625 Tubes
Posted: Thu Jan 02, 2020 2:31 pm
by Dunkman
Is that Hawk Innovative Tech? This is the only forum I am on other than reddit.
Re: 1.625 Tubes
Posted: Fri Jan 03, 2020 7:50 am
by EastTxHorn
I don't see a Hawk Tactical on any of the boards that sells parts?
Re: 1.625 Tubes
Posted: Sun Jan 05, 2020 7:30 pm
by #40Fan
Sorry, I goofed that up.
Hawkstand
http://form1suppressor.boards.net/threa ... ew-website
http://spectrum-inc.com/
Contact him through the site and let him know what you are looking for. He supplies tubes for SPC.
Re: 1.625 Tubes
Posted: Wed Jan 08, 2020 10:49 am
by EastTxHorn
No luck there either. Seems everyone is out at the moment? Anyone else have any ideas?
Re: 1.625 Tubes
Posted: Wed Jan 08, 2020 2:55 pm
by Dunkman
Maybe
https://www.titaniumjoe.com/ has what you need? I've never used them. Do you need them threaded or do you plan to do them yourself?
Re: 1.625 Tubes
Posted: Wed Jan 08, 2020 10:38 pm
by EastTxHorn
I need them threaded. I've never threaded tubes. Is it difficult?
Re: 1.625 Tubes
Posted: Thu Jan 09, 2020 8:21 am
by Dunkman
At the bottom of their page it says they now offer machine shop services, but like I said I've never used them before.
Re: 1.625 Tubes
Posted: Thu Jan 09, 2020 10:27 am
by fishman
EastTxHorn wrote: ↑Wed Jan 08, 2020 10:38 pm
I need them threaded. I've never threaded tubes. Is it difficult?
Do you have a lathe? It's not hard