Here is my first attempt at drawing a 7.62 mono core.
My plan was to keep the first set of holes symmetrical. Then stagier holes the rest of the way. The end hole will be symmetrical with the bore. I would like to thread the core to the bore directly. I would have the outer tube thread on to the core and tighten to a lip. I would weld the end cap to the outer tube. I plan on making this out of 416 ss Other than that I need help with dimensions. What are you thoughts. Is there anyone that has done something similar... that is willing to share. I would love it if we could put this in 3d drawing but I don't have any cad software or experience since high school. I welcome your opinions and questions. Thank you all. Tom R
My first attempt at a monocore 7.62
- ghostdog662
- Silent But Deadly
- Posts: 655
- Joined: Thu Mar 06, 2008 3:19 pm
- Location: TX
Re: My first attempt at a monocore 7.62
Why not go with 60% cones at .06 thick. You could then spend time designing the flash suppressor part.
Some may not put too much effort into the FH but it will prevent bore erosion at the muzzle
You could also research baffle spacing, blast chamber length, materials, welding, etc…
I build mono-cores for 22s but would not use it for center fire rifle
Some may not put too much effort into the FH but it will prevent bore erosion at the muzzle
You could also research baffle spacing, blast chamber length, materials, welding, etc…
I build mono-cores for 22s but would not use it for center fire rifle
Re: My first attempt at a monocore 7.62
Big time. It might be dangerous as is. Wear safety goggles.ghostdog662 wrote:You need some expansion chamber action.
"Buzzards gotta eat, same as worms."
www.hooperordnance.com
www.hooperordnance.com
Re: My first attempt at a monocore 7.62
How about this way?
I Am trying to get an idea of how this should work.
I Am trying to get an idea of how this should work.
- ghostdog662
- Silent But Deadly
- Posts: 655
- Joined: Thu Mar 06, 2008 3:19 pm
- Location: TX
Re: My first attempt at a monocore 7.62
You definitely want to take a look at this thread:tjsr19 wrote:How about this way?
I Am trying to get an idea of how this should work.
viewtopic.php?f=10&t=63889
You are probably going to want your expansion chamber to end where your third center circle ends. Probably at least 3" in length
LP
Re: My first attempt at a monocore 7.62
You definitely want to take a look at this thread:
viewtopic.php?f=10&t=63889
You are probably going to want your expansion chamber to end where your third center circle ends. Probably at least 3" in length[/quote]
Thank you very much. This is what I needed.
viewtopic.php?f=10&t=63889
You are probably going to want your expansion chamber to end where your third center circle ends. Probably at least 3" in length[/quote]
Thank you very much. This is what I needed.