Page 1 of 1

Time for the chips to fly, #3 just came back.

Posted: Tue Aug 14, 2012 10:03 am
by rqlasl
Time for the lathe to earn its rent. My 3rd form 1 just came back.
I signed and mailed on Feb. 6th and it was approved Aug 2nd just shy of 7 months.
Let it begin!

Re: Time for the chips to fly, #3 just came back.

Posted: Tue Aug 14, 2012 12:14 pm
by twodollarbill
......and women wonder why we get get so excited 8)

Re: Time for the chips to fly, #3 just came back.

Posted: Wed Sep 05, 2012 1:41 pm
by featherhead
@ rqlasl

I'm wanting to start a from 1 and have not found any info on when an individual build can begin. Is it absolutely and not a minute before the tax stamp is in your hand? Is there any way around doing some advanced prototyping or fabbing maybe a threaded barrel adapter?

Re: Time for the chips to fly, #3 just came back.

Posted: Wed Sep 05, 2012 3:33 pm
by rqlasl
You may not begin any fabrication of the suppressor or any parts that go on or in the suppressor until your approved form 1 is stamped and back in your hands.
Then and only then let the chips fly!

Re: Time for the chips to fly, #3 just came back.

Posted: Wed Sep 05, 2012 4:58 pm
by Bendersquint
featherhead wrote:@ rqlasl

I'm wanting to start a from 1 and have not found any info on when an individual build can begin. Is it absolutely and not a minute before the tax stamp is in your hand? Is there any way around doing some advanced prototyping or fabbing maybe a threaded barrel adapter?
Didn't you read my post that you responded to?

ETA - I see you did, you posted in the main forum after posting this.