P220 & Ti-Rant 45 question

[Gik-Tal]

For those of you that have a P220 and a Ti-Rant 45, can you use the factory sights and if not what are you using?

[Bendersquint]

For those of you that have a P220 and a Ti-Rant 45, can you use the factory sights and if not what are you using?

Factory sights won't clear it.

I use Ameriglo on my 1.375" OD tubes with the P220.

[tsands974]

For those of you that have a P220 and a Ti-Rant 45, can you use the factory sights and if not what are you using?

Factory sights won't clear it.

I use Ameriglo on my 1.375" OD tubes with the P220.

This ^. The tall Ameriglo sights are the way to go, no target obstruction.

[Gik-Tal]

I've been hearing conflicting reports on the Ameriglo sights, one place you read says that they clear, another forum writer says that they are just a little short, Thank you all for your assistance, going to order a set soon.

[Lateck]

Factory sights won't clear it.

I use Ameriglo on my 1.375" OD tubes with the P220.

Good to know. I have the same set-up ( P220/TiRant).

Lateck,

Edit: Just ordered the Ameriglo sights. Will have next week so I'll up-date everyone. 08/16/14

[Artful]

so did you mount the sights on the 220 and did they clear the Tirant?

[Gik-Tal]

Yes I got them installed and they work great. Did have to buy a new sight installation tool however, the standard MGW Sig sight tool does not provide enough clearance to install or adjust the higher sights. I ended up ordering one of the new MGW Sight Pro universal tools, and that works just great. I also ordered a second set for my P226 in 9mm and they work with the TI-Rant 45 great also. If you are looking for an alternate sight, I had to have a set made for my Rock Island 1911 45. In order to get a set that would clear the suppressor on that I had to send the slide to Dawson Precision and they made a custom height set for me.