Page 1 of 1

Glock 19 factory tb wear/tear question

Posted: Mon Apr 14, 2014 10:34 pm
by CanNotHear
Any parts I should change out or upgrade to avoid additional wear and tear? I'm running a Gen 3 Glock 19 with a Glock factory threaded barrel. Only a couple hundred rounds suppressed out of this host thus far, seems fine. Just wanting to know if I am forgetting to upgrade anything or maybe if a few parts could be upgraded as a precaution to slow down additional wear.

Re: Glock 19 factory tb wear/tear question

Posted: Mon Apr 14, 2014 10:48 pm
by Bendersquint
CanNotHear wrote:Any parts I should change out or upgrade to avoid additional wear and tear? I'm running a Gen 3 Glock 19 with a Glock factory threaded barrel. Only a couple hundred rounds suppressed out of this host thus far, seems fine. Just wanting to know if I am forgetting to upgrade anything or maybe if a few parts could be upgraded as a precaution to slow down additional wear.
Nothing to worry about at all.

You will never shoot that barrel enough to cause any damage to the gun anyways.