I have a Ruger Mk 2 Target with a 5.5" bull barrel and a TBAC 22 Take Down can.

Is the SOP to have it sent off to a gunsmith, cut to 4.5" and threaded?

Best Regards,
tnjaeger

tnjaeger wrote:I have a Ruger Mk 2 Target with a 5.5" bull barrel and a TBAC 22 Take Down can.

Is the SOP to have it sent off to a gunsmith, cut to 4.5" and threaded?

Best Regards,
tnjaeger

By the time you pay a gunsmith, you might be better off selling yours and buying a factory threaded one. I have a mk2 22/45 I'm gonna suppress, but I'm doing the threading myself.

The easiest route (but not the cheapest) is to just get a Tac Sol upper like I did.

http://www.tacticalsol.com/2245-and-mk- ... ded-barrel