Trident 9 end cap

happycamper · Post by **happycamper** » Sat Apr 19, 2014 7:01 pm

Should the end cap be completely sealed to the can? The reason I ask is that when I clean it, cleaner(kroiloil) runs out around the seam of the end cap to the can. There is a small open seam there. About the width of a dollar bill.

Bendersquint · Post by **Bendersquint** » Sat Apr 19, 2014 7:39 pm

happycamper wrote:Should the end cap be completely sealed to the can? The reason I ask is that when I clean it, cleaner(kroiloil) runs out around the seam of the end cap to the can. There is a small open seam there. About the width of a dollar bill.

No, thats fine.

You know that Kroil doesn't do anything to clean cans right? It just removes the lose surface dust that hasn't bonded to the baffles yet.

Get it jailbroken and you can clean your baffles for real.

happycamper · Post by **happycamper** » Sun Apr 20, 2014 11:34 am

How would you suggest cleaning it?

Bendersquint · Post by **Bendersquint** » Sun Apr 20, 2014 4:12 pm

happycamper wrote:How would you suggest cleaning it?

Have it jailbroken so you can remove the baffles and then a nylon brush and elbow grease or soda blaster.

Cant fully clean the baffles with them locked inside, you cant access the bad spots.

paper9 · Post by **paper9** » Sun Apr 20, 2014 10:24 pm

What is soda blaster? Thanks.

Bendersquint · Post by **Bendersquint** » Sun Apr 20, 2014 10:42 pm

paper9 wrote:What is soda blaster? Thanks.

Uses compressed air to blast baking soda to clean parts, its less damaging than abrasive media like aluminum oxide.

http://www.harborfreight.com/15-lb-port ... 60802.html

Trident 9 end cap

Trident 9 end cap

Re: Trident 9 end cap

Re: Trident 9 end cap

Re: Trident 9 end cap

Re: Trident 9 end cap

Re: Trident 9 end cap