13.5x1LH piston O-ring size?
Moderators: Kenny_SilencerCo, Andrew@Silencerco
13.5x1LH piston O-ring size?
I have searched to no avail... Can anyone tell me what size viton O-ring the 13.5x1LH octane piston has inside of it? I am in need of some replacements/spares and would like to get them in bulk rather than one or two at a time. Thanks.
Re: 13.5x1LH piston O-ring size?
Should be 14mm (OD) x 1mm. Standard size across all manufacturers.
Re: 13.5x1LH piston O-ring size?
Thank you - I will get some and try them out.
- kc_silencerco
- Silent Operator
- Posts: 59
- Joined: Fri Feb 14, 2014 11:19 am
- Location: West Valley, UT
- Contact:
Re: 13.5x1LH piston O-ring size?
The 13.5x1 LH piston o-ring's size is 1x12mm
Last edited by kc_silencerco on Wed Mar 11, 2015 3:33 pm, edited 1 time in total.
Re: 13.5x1LH piston O-ring size?
OK, thanks again.
Re: 13.5x1LH piston O-ring size?
So what size is the o-ring in a .578-28 piston?
[url=http://militarysignatures.com][img]http://militarysignatures.com/signatures/member1236.png[/img][/url]
- kc_silencerco
- Silent Operator
- Posts: 59
- Joined: Fri Feb 14, 2014 11:19 am
- Location: West Valley, UT
- Contact:
Re: 13.5x1LH piston O-ring size?
There are no o-rings in the standard thread pistons. Only metric threaded pistons call for the o-ring.
Re: 13.5x1LH piston O-ring size?
I realize this is an old thread but I'm new on here and didn't want to start a new one. Here is my question.....
What is the size and/or dimensions for the o-ring for the M16x1LH piston for an HK USP .45T with a Octane .45? Any info is greatly appreciated.
What is the size and/or dimensions for the o-ring for the M16x1LH piston for an HK USP .45T with a Octane .45? Any info is greatly appreciated.