Could an Octane 45 be sent in for 9mm baffles?

Company specific discussions and announcements.

Moderators: [email protected], Kenny_SilencerCo

Post Reply
DrDremel
Senior Silent Operator
Posts: 133
Joined: Mon Jan 02, 2006 8:10 pm
Location: Ortonville, MI

Could an Octane 45 be sent in for 9mm baffles?

Post by DrDremel » Tue Jul 01, 2014 5:45 pm

Making it an extra quiet 9mm silencer?

RJT
Silent But Deadly
Posts: 718
Joined: Wed Jul 31, 2013 4:42 pm
Location: SoTx

Re: Could an Octane 45 be sent in for 9mm baffles?

Post by RJT » Tue Jul 01, 2014 6:03 pm

Nope, can't change bore diameter once caliber has been designated.
You keep using that word. I do not think it means what you think it means.

rimshaker
Silent But Deadly
Posts: 1038
Joined: Mon Jul 23, 2012 11:15 am
Location: FL

Re: Could an Octane 45 be sent in for 9mm baffles?

Post by rimshaker » Tue Jul 01, 2014 11:20 pm

Guessing that also applies to just swapping the endcaps?

RJT
Silent But Deadly
Posts: 718
Joined: Wed Jul 31, 2013 4:42 pm
Location: SoTx

Re: Could an Octane 45 be sent in for 9mm baffles?

Post by RJT » Tue Jul 01, 2014 11:24 pm

Apparently not. Saker 7.62 can be fitted with a 5.56 endcap. Must not be considered a silencer part, but baffles are another story.
You keep using that word. I do not think it means what you think it means.

jt526
Silent But Deadly
Posts: 571
Joined: Wed May 07, 2008 9:56 pm
Location: Dallas, TX

Re: Could an Octane 45 be sent in for 9mm baffles?

Post by jt526 » Wed Jul 02, 2014 2:12 am

The endcap on the saker isn't really an endcap in the sense that it holds the baffles in, the endcap on the saker is just an accessory. I'm betting ATF would have a negative opinion of putting the 5.56 on the 7.62 though. But I also thought that sig brace thing would be shot down after what some yahoos are doing with it, sooooo...there's that.
Stupid, stupid NFA items.

Post Reply