Octane45 HK LH threads

Company specific discussions and announcements.

Moderators: [email protected], Kenny_SilencerCo

Post Reply
Cyclepath37
New Member
Posts: 1
Joined: Sun Sep 27, 2015 2:06 pm

Octane45 HK LH threads

Post by Cyclepath37 » Sun Sep 27, 2015 2:12 pm

When shooting the Octane45 on an HK LH thread, everytime I give it a snug I break loose the rear cap which is RH thread. What trick does everyone use? Tighten the rear cap extra tight before threading on barrel so every snug check will not loosen rear cap?

User avatar
chrismartin
Silencertalk Goon Squad
Posts: 4226
Joined: Sun Mar 12, 2006 9:18 pm
Location: Tidewater, VA

Re: Octane45 HK LH threads

Post by chrismartin » Sun Sep 27, 2015 7:47 pm

Just the rear cap or the entire booster housing that's threaded into the tube?
I can see the booster housing coming loose, but not just the rear cap.
If it's the booster housing, I'd clean it up and locktite it back (or send it in to SilCo to do the same). That part is not supposed to come loose.

User avatar
Jstam
Member
Posts: 13
Joined: Wed Dec 24, 2014 1:20 pm
Contact:

Re: Octane45 HK LH threads

Post by Jstam » Mon Sep 28, 2015 10:41 am

Cyclepath37
If the booster housing is spinning we will definitely want to get the suppressor back to us. We can get you back up and running very quickly, if you have any questions please fill free to contact us at [email protected].

Thanks
Jacob Stam
Customer Service Manager
Silencerco
[email protected]

Post Reply