Octane45 HK LH threads
Moderators: Kenny_SilencerCo, Andrew@Silencerco
-
- New Member
- Posts: 1
- Joined: Sun Sep 27, 2015 1:06 pm
Octane45 HK LH threads
When shooting the Octane45 on an HK LH thread, everytime I give it a snug I break loose the rear cap which is RH thread. What trick does everyone use? Tighten the rear cap extra tight before threading on barrel so every snug check will not loosen rear cap?
- chrismartin
- Silencertalk Goon Squad
- Posts: 4226
- Joined: Sun Mar 12, 2006 7:18 pm
- Location: Tidewater, VA
Re: Octane45 HK LH threads
Just the rear cap or the entire booster housing that's threaded into the tube?
I can see the booster housing coming loose, but not just the rear cap.
If it's the booster housing, I'd clean it up and locktite it back (or send it in to SilCo to do the same). That part is not supposed to come loose.
I can see the booster housing coming loose, but not just the rear cap.
If it's the booster housing, I'd clean it up and locktite it back (or send it in to SilCo to do the same). That part is not supposed to come loose.
Re: Octane45 HK LH threads
Cyclepath37
If the booster housing is spinning we will definitely want to get the suppressor back to us. We can get you back up and running very quickly, if you have any questions please fill free to contact us at [email protected].
Thanks
If the booster housing is spinning we will definitely want to get the suppressor back to us. We can get you back up and running very quickly, if you have any questions please fill free to contact us at [email protected].
Thanks