Has any member out their familiar with this modification on Cone baffles, photos are from a listing on Sturm board on stainless cone baffles, any ideas on improvement with this mod ?
Cone Baffle Modification
Moderators: mpallett, mr fixit, bakerjw, renegade
Re: Cone Baffle Modification
Just the run of the mill single clip using a ball nosed end mill. Clipping is a must do to get the best results.
- whiterussian1974
- Silent But Deadly
- Posts: 2857
- Joined: Sat Sep 28, 2013 11:37 pm
- Location: On 8th line of eye chart.
Re: Cone Baffle Modification
For this design, there isn't any commonly used improvement.
If the skirt was pulled .25" in from the OD, then you could port the opposite side into the co-axial space. (Known as a "mouse hole.")
But this design doesn't offer this option.
If the skirt was pulled .25" in from the OD, then you could port the opposite side into the co-axial space. (Known as a "mouse hole.")
But this design doesn't offer this option.
The Darkest Corners of Hell are reserved for those who remain Neutral!-Dante
The Death of One is a Tragedy, a million only a statistic.-Stalin
silencertalk.com/forum/viewtopic.php?f=10&t=135314
The Death of One is a Tragedy, a million only a statistic.-Stalin
silencertalk.com/forum/viewtopic.php?f=10&t=135314