Hagelberg Arms - New prototype suppressor for the GSG5-SD
Posted: Sun Jun 21, 2009 6:32 pm
Now i have almost finished my project with a new suppressor for the GSG5-SD. This is only a prototype, the surface will come in black anodized. And the tubes surface in glassblasted or knurled (customers choice)
Later this week i will have about 6 inch of the barrel perforated, for a better sound reduction (i hope), but i think i will work. The bullet will go a little slower, and the gases will have more time to vent into the tube.
http://www.youtube.com/watch?v=7hOwJkUss5U
Eventually search the youtube for some of my other videos, there are some with my new line of cans, tested on .308 .300WinMag and .338LapuaMagnum
Later this week i will have about 6 inch of the barrel perforated, for a better sound reduction (i hope), but i think i will work. The bullet will go a little slower, and the gases will have more time to vent into the tube.
http://www.youtube.com/watch?v=7hOwJkUss5U
Eventually search the youtube for some of my other videos, there are some with my new line of cans, tested on .308 .300WinMag and .338LapuaMagnum