What I would like to do is not only cast my own brass and bullets but cast 100s at a time.
I did some searching and all I can find is a ton of information about hand loading. I can't seem to find any molds for brass or molds for anything other then lead bullets. I'd like to cast FMJ and JHP.
Can someone please point me in the right direction?
manufacturing your own ammunition
Here are a couple of articles I found on how brass cartridges are made.
http://accurateshooter.wordpress.com/20 ... s-is-made/
http://www.chuckhawks.com/cartridge_case.htm
http://accurateshooter.wordpress.com/20 ... s-is-made/
http://www.chuckhawks.com/cartridge_case.htm
"And by the way, if you're gonna take up a hobby of letter writing, you might want to learn how to spell "writing" you stupid F--k." - Nighthawk re kwikrnu
Corbin Bullet swaging materials
http://www.bulletswage.com/topics.htm
Corbin Bullet Swaging E-book
http://www.scribd.com/doc/246176/Chapt-1
Homemade Ammo E-Book
http://www.scribd.com/doc/13128512/home ... adin-press
http://www.bulletswage.com/topics.htm
Corbin Bullet Swaging E-book
http://www.scribd.com/doc/246176/Chapt-1
Homemade Ammo E-Book
http://www.scribd.com/doc/13128512/home ... adin-press