Edited to change thread title. I realized it was a near duplicate of another thread.
I purchased a bullet sizer from D Rock over on Rimfire Central and I've been working with the 60gr Aguila loads for a few days. I'm very happy with the results that I have been getting. Below are some pictures and info.
To use the tool place the cartridge in the base, which prevents the rim from getting crushed.
Then, place the adjusted hollow point tool in the upper portion of the tool and place the assembly on the base. I found that using the flat faced tool first helps to ensure that the hollow point tool is well centered on the bullet, as it isn't trying to center on the round nose.
Once assembled, give it a couple light raps with a mallet to drive the tool into the nose of the bullet.
The result is a bullet that has a hollow point and is shorter, which may help with stabilization.
Here is the result of some expansion tests. I tested them in plumber's putty, water, and on small game. They will expand and travel length-wise through a squirrel, head to tail.
For more aggressive expansion I found that driving the nose of a small phillips head screwdriver into the hollow point when it is still in the tool helps even more. Prestressing the bullet at four points causes it to expand very rapidly, but sometimes some of the four petals will break off.
Accuracy is the same for me, but I am using a Lilja 1:9 twist barrel on a 77/22, so I never had a problem with the accuracy of these rounds.
Modifying 60gr 22LR bullets
- smcharchan
- Silent But Deadly
- Posts: 2268
- Joined: Thu Dec 20, 2007 6:06 am
- Location: VA
- smcharchan
- Silent But Deadly
- Posts: 2268
- Joined: Thu Dec 20, 2007 6:06 am
- Location: VA
It does not affect the sound of the 60gr round.diablito wrote:how does this effect sound?
The increased pressure created by the tighter bullet does have an effect with certain rounds; it will make some go a little sonic. For example, CCI standard velocity and CCI subsonic HP both make just a little bit of a crack when sized then fired - not a full blown crack, but you can definately hear some bullet noise. They must be right on the lower boundry of the transonic range. However, all my testing has been here in VA last week where the temps have been 10 to 30 degrees.
- smcharchan
- Silent But Deadly
- Posts: 2268
- Joined: Thu Dec 20, 2007 6:06 am
- Location: VA
The words "over on Rimfire Central" in my post is a hyperlink. Click it to get in contact with the mfr, who uses the screen name "D Rock".eseaton wrote:Any info on how to get more info on this? Manufacturer, etc?
Thanks
D Rock is not the only guy making these. As Ron stated above, there is the Neal Waltz model that works in a reloading press, and there is one made by Paco Kelly’s called the ACU-RZR (link).
They are a great way to make ammo more accurate, to make solid points into hollow points, and to waste hours tinkering.
- silentassets
- Silent But Deadly
- Posts: 829
- Joined: Sat Feb 24, 2007 6:13 pm
- Location: Texas
- libertyman777
- Silent But Deadly
- Posts: 553
- Joined: Sun Feb 17, 2008 8:46 am