So recently I gave Gary (he's still in the 'springs) my old single stack 1911 to create a carry gun from it. I was going to use the original slide and barrel, making a .38 Super carry gun but he discovered that the slide had cracked (back then Caspian used castings, now they're made from billets). At that point I decided to just go .45 ACP (which will enable me to sell my old Gold Cup at some point).
It's done, and boy is it done well. Not a single sharp edge on it, the entire gun feels all "roundy". It has my old Caspian frame sporting a new black Cerakote finish, a stainless steel Caspian slide that has been given the flattop treatment and a KKM Precision barrel (had to go with a ramped barrel due to the frame originally being cut for a ramped .38 Super barrel).
Impeccable fit and finish, hopefully I'll get some time on Sunday to take it out and throw some lead downrange!
If you look really close you can see a "beauty mark" just in front of the slide stop - that's where one of the screws for the scope mount was before he filled it in. He wanted to weld it up and smooth it down but I told him to just plug it, so that's my fault, not his!


O2
Ps. Some gunsmiths may remember Gary as one of the Trinidad College gunsmithing instructors from back in the 80s -- he taught beside the likes of Ron Powers and many of the "old names".