Launched my SilencerCo Omega300 - Repair?
Posted: Mon Jul 01, 2019 4:17 pm
I launched my SilencerCo Omega 300 20yd today on the first 556 round from my Tavor X95. I last shot ~1000rd in May and did a thorough cleaning of the rifle, and pulled off the ARS Mount and cap to brush it out. I have the muzzle brake fixed with Rockset and it's still solid.
I must have cross-threaded it when I reassembled - I can't think of any other reason it would be misaligned.
I'll check with my FFL to see if it can go back for repair or replacement - maybe they can get a better cost than I can direct.
I assume if replaced I can do so w/o a new tax stamp if SilencerCo destroys the old one and put the old SN on a new one?
Advice appreciated - I think I know what an alignment rod is good for now
I must have cross-threaded it when I reassembled - I can't think of any other reason it would be misaligned.
I'll check with my FFL to see if it can go back for repair or replacement - maybe they can get a better cost than I can direct.
I assume if replaced I can do so w/o a new tax stamp if SilencerCo destroys the old one and put the old SN on a new one?
Advice appreciated - I think I know what an alignment rod is good for now