Short monocore 9mm.
Posted: Thu Jan 20, 2022 10:19 am
Form 1 cleared in 20 days btw
Any good posts here about monocore designs? I've done an sd like build that's mouse fart level but there was a lot of room for error in that. I got about 6 inches of length that can be milled out and the od of the core is going to be 1.875 inches. Really too short to guess randomly. I rather stick to 3 axis milling but I could free up the 5 axis if I'm willing to wait a long ass time for it to be free for my nonsense.
100% aluminum. I think its 6061 but it's been in the scrap pile so long
Any good posts here about monocore designs? I've done an sd like build that's mouse fart level but there was a lot of room for error in that. I got about 6 inches of length that can be milled out and the od of the core is going to be 1.875 inches. Really too short to guess randomly. I rather stick to 3 axis milling but I could free up the 5 axis if I'm willing to wait a long ass time for it to be free for my nonsense.
100% aluminum. I think its 6061 but it's been in the scrap pile so long