Does anyone have a 9mm 147 Gr. load that has little to no blowback when used on a can?

Be careful -- low-volume ratio loads can detonate. Mangement not responsible for load data. Use at your own risk.

Moderators: mpallett, bakerjw

Post Reply
moreguns
Member
Posts: 14
Joined: Mon Oct 13, 2014 6:05 am

Does anyone have a 9mm 147 Gr. load that has little to no blowback when used on a can?

Post by moreguns »

I have had bad blowback with 45 ACP , till I came up with this load. Now I want to use my octane 45 HD with a 9 end cap and A Rugged suppresors piston I need some suggestions. For 45 ACP I use a Redding duel ring carbide sizer , Federal match standard primer.230 FMJ, 5 grains of 700X and taper crimp-.001" .
User avatar
jmorris
Silent But Deadly
Posts: 427
Joined: Mon May 12, 2008 8:36 am

Re: Does anyone have a 9mm 147 Gr. load that has little to no blowback when used on a can?

Post by jmorris »

A Berry’s 147 RN @ 1.160” with 3.1 of VV N310 or 3.2 gn N320 or 3.2 of Titegroup.
quiettime
Silent But Deadly
Posts: 605
Joined: Sat Dec 13, 2014 8:11 pm
Location: N FLA

Re: Does anyone have a 9mm 147 Gr. load that has little to no blowback when used on a can?

Post by quiettime »

I'm using Xtreme 147 plated HP over 3.6 grains of Titegroup. Very little gunk in the action so far but also 100% reliability
Post Reply